GE WPGT9350 Technical Service Manual page 55

5. Disconnect the ribbon at the right of the
washer control board by pulling the connector
at the end of the ribbon off the metal pins.
Note: Do not disconnect any other wires from
the washer control board.
Rear of Washer
6. Remove the 4 Phillips head screws holding
the washer control board to the backsplash
then remove the control board and set it aside.
Screws
7. Place a towel over the top surface of the dryer
to prevent scratches to the surface.
8. Remove the 4 Phillips head screws from the
dryer backsplash. Rotate backsplash forward
and lift off.
Screws
Rear of Drye r
9. Disconnect the ribbon at the right of the dryer
control board by pulling the connector at the
end of the ribbon off the metal pins.
Note: Do not disconnect any other wires from
the dryer control board.
10. Remove the 4 Phillips head screws holding
the dryer control board to the backsplash.
11. Remove the dryer control board and set it
aside.
Screws
– 55 –
Rear of Dryer
Screws
(Continued Next Page)