To remove the clutch shifter assembly:
1. Remove the rotor. (See
2. Remove the three Phillips head screws from
the clutch coupler plate.
3. Remove the clutch coupler assembly.
4. Disconnect the wiring connector from the
clutch motor.
5. Remove the two 10-mm hex-head screws that
hold the clutch motor in place. Remove the
clutch motor.
)
Motor Assembly.
– 37 –
Bearing Housing Assembly
To remove the bearing housing Assembly:
1. Remove the
Motor Assembly
.
Shifter Assembly
2. Remove the screw that holds the ground
wire to the bearing housing. Remove all the
10-mm hex-head screws on the bearing
housing assembly
Note: When reassembling, be sure to put the
motor and Hall sensor wires back in the wiring
guard away from the motor.
and
Clutch