Table of Contents
Advertisement
Error Message
Cause
The machine is out of paper or
No Paper Fed
paper is not properly loaded in the
paper tray.
The paper is jammed in the
machine.
No Response/Busy
The number you dialed does not
answer or is busy.
Not Registered You tried to access a Speed Dial
number that is not programmed.
The machine's memory is full.
Out of Memory
Paper is jammed in the machine.
Paper Jam
The machine has a mechanical
Print Unable
problem.
XX
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
The machine has a mechanical
Scan Unable
problem.
XX
—OR—
A foreign object such as a clip or
ripped paper is in the machine.
Unusable Device A broken device has been
connected to the USB direct
interface.
90
Action
Do one of the following:
Refill the paper in the paper tray, and then
press Mono Start or Colour Start.
Remove the paper and load it again and then
press Mono Start or Colour Start.
See Printer jam or paper jam on page 92.
Verify the number and try again.
Set up the Speed Dial number. (See Storing
Speed Dial numbers on page 44.)
Fax sending or copy operation in progress
Press Stop/Exit and wait until the other
operations in progress finish and then try again.
Printing operation in progress
Reduce print resolution. (For details, see Printing
®
for Windows
or Printing and Faxing for
®
Macintosh
in the Software User's Guide on the
-
CD
ROM.)
Remove the Jam Clear Cover (at the back of the
machine) and pull out the jammed paper. See
Printer jam or paper jam on page 92.
Open the scanner cover and remove any foreign
objects inside the machine. If the error message
continues, see Transferring your faxes or Fax
Journal report on page 91 before disconnecting
the machine so you will not lose any important
messages. Then, disconnect the machine from
the power for several minutes and then
reconnect it.
Open the scanner cover and remove any foreign
objects inside the machine. If the error message
continues, see Transferring your faxes or Fax
Journal report on page 91 before disconnecting
the machine so you will not lose any important
messages. Then, disconnect the machine from
the power for several minutes and then
reconnect it.
Unplug the device from the USB direct interface,
then press Power Save to turn the machine off
and then on again.
Advertisement
Table of Contents
