Graco GH 833 249318 Repair Manual page 20

Belt Removal and Replacement
(recommended method)
Removing Belt
a. Place a ziptie around belt (19).
19
ziptie
Moving parts can pinch or amputate fingers and other
body parts. To avoid serious injury be sure engine is in
OFF position before pulling engine recoil.
b. Slowly pull ziptie toward you while at the same
time slowly pulling engine recoil to rotate pul
leys. It may be necessary to reposition zip tie
and repeat this procedure a few times to com
pletely remove belt from pulley.
ti7842
20
ti7843
Installing Belt
a. Put belt over lower pulley (6) and align correctly.
b. Line up belt over top left side of large pulley (4).
c. With the palm of your hand, hold the belt snug
to large pulley while at the same time slowly pull
engine recoil to rotate pulleys.
d. Check belt (19) alignment on both large (4) and
small pulley (6). When properly positioned over
pulleys, belt is centered on pulleys and com
pletely over all grooves.
ti7834
Properly Aligned
NOTE: If belt is not aligned properly, to adjust belt, slowly
pull engine recoil while at the same time pushing or pull
ing belt to reposition over pulley.
Hydraulic Pump Replacement
ti7869
ti7837
Not Aligned Properly
311283H