Maintenance - Panasonic CQ-VD7500U Operating Instructions Manual

Maintenance

E
N
G
L
I
S To Prevent Damage to the System Exterior
H
Do not apply pesticides, benzine, thinner or other volatile substances to the unit.
70
The cabinet surface primarily consists of plastic materials.
Do not wipe with benzine, thinner or similar substances because this will result in
discoloration or removal of the paint.
When a cloth with a cleansing chemical is used, follow the caution points.
Do not leave the unit in contact with rubber or vinyl products for long periods of
time.
Do not use cleansers which have polishing granules because this could damage
the surface of the unit.
Clean Dirt by Wiping Lightly with a Soft Cloth
When the unit is dirty, wipe the surface of the display using the Wiping Cloth (supplied).
OPEN
VOLUME
Without a Wiping Cloth
When the unit is dirty, wipe with a well-wrung cloth dipped in liquid dishwashing detergent (neutral) diluted with water
and then go over the same surface with a dry cloth.
(Since there is the possibility of water drops getting inside of the unit, do not directly apply cleanser to the surface.)
Note: Do not scratch the screen with your nails or other hard objects. The resulting scratches or marks will obscure the
image.
Caution: If water drops or similar wet substances get inside the monitor, it may cause a malfunction.
Product Servicing
If the suggestions in the charts do not solve the problem, we recommend that you take it to your nearest authorized
Panasonic Servicenter. The product should be serviced only by a qualified technician.
Replacing the Fuse
Use fuses of the same specified rating (5 A for display unit, 15 A for hide-away unit). Using different substitutes or fuses
with higher rating, or connecting the product directly without a fuse, could cause a fire or damage to this unit.
If the replacement fuse fails, contact your nearest Panasonic Servicenter for service.
86
CQ-VD7700U/VD7500U
Pesticide
Alcohol
Thinner
Benzine
Wipe lightly.
TILT OPEN / CLOSE
OPEN / CLOSE
CQ-VD7700U TILT
CQ-VD7700U
IN-DASH 7" WIDESCREEN COLOR LCD MONITOR TV / DVD / SD RECEIVER TRACK/
CHANNEL
ENTER
DISC
MUTE NAVI DISP MODE ASP SD CARD
P·MODE
NAVIGATION POWER ASPECT
How to hold the disc
Wax
¡Do not touch the underside of the disc.
Tape
¡Do not scratch the disc.
¡Do not bend disc.
¡When not in use, keep disc in the case.
Do not use irregularly shaped discs.
Adhesive
Tape Disc insert
The surfaces of new discs tend to be slippery. Therefore, when
using such a disc for the first time, it may not load satisfactorily
even when it has been inserted into the main unit. At a time like
this, insert the disc into the main unit as far as it will go until it
is loaded properly.
Do not leave discs in the following places:
¡Direct sunlight
¡Near car heaters
¡Dirty, dusty and damp areas
¡On seats and dashboards
Disc cleaning
Use a dry, soft cloth to wipe from the center outward.
Do not attach any seals or labels to your discs.
Do not write on the disc label with a heavy pen or
ballpoint pen.
¡You may have trouble playing back some CD-R/RW discs recorded on CD recorders (CD-R/RW drives), either due to
their recording characteristics or dirt, fingerprints, scratches, etc. on the disc surface.
¡CD-R/RW discs are less resistant to high temperatures and high humidity than ordinary music CDs. Leaving them inside
a car for extended periods may damage them and make playback impossible.
¡The unit may not successfully play back a CD-R/RW that was made by the combination of writing software, a CD
recorder (CD-R/RW drive) and a disc if that are incompatible with one another.
¡This player cannot play CD-R/RW discs if the session is not closed.
¡This player cannot play CD-R/RW discs which contain other than CD-DA or MP3 data (Video CD, etc.).
¡Be sure to observe the handling instructions of CD-R/RW discs.
Notes on Discs
Label side
Do not use irregularly shaped discs.
<Right>
Notes on CD-Rs/RWs
CQ-VD7700U/VD7500U
E
N
G
L
I
S
H
71
<Wrong>
87