General - Panasonic CQ-VD7500U Operating Instructions Manual

General

E
N
G
L
I
S
[MODE] (POWER)
H
18
CQ-VD7700U
IN-DASH 7" WIDESCREEN COLOR LCD MONITOR TV / DVD / SD RECEIVER
OPEN
VOLUME MUTE MUTE NAVI DISP MODE MODE
NAVIGATION POWER
[VOLUME]
[MUTE]
Remote Control Sensor
Example: DVD VIDEO
TILT
B
A
TILT
CQ-VD7700U
CQ-VD7700U
[PWR] (Power) [MODE]
NAVIGATION
PWR PWR NAVI MODE MODE MENU
STOP PAUSE PLAY CHAPTER
OSD
[ ] ] [ [ ]
TOP MENU RETURN
RET
(adjust)
DVD / SD MENU RANDOM REPEAT SCROLL
RAND REP PAGE
ST/ MONO SUBTITLE TRACK
AUDIO ANGLE SUB GRP
TITLE / CHAPTER
CH1 CH2
1 2 3
DISP
SCAN
4 5 6 [ } ] [ { ] (VOL)
VOL VOL
7 8 9
[MUTE]
ASPECT
A 0 SPACE MUTE MUTE
P-MODE
CAR AV
34
CQ-VD7700U/VD7500U
[TILT]
OPEN / CLOSE
[ ] (OPEN/CLOSE)
TILT TILT
TRACK/
CHANNEL
[]] [[]
ENTER ENTER ENTER
DISC
(Adjust)
SD CARD
ASP
P·MODE
ASPECT
Power
OPEN / CLOSE
Turn your car's ignition key to ACC or ON position.
ON: press [MODE] (POWER) on the display unit.
Press [PWR] or [MODE] on the remote control.
OFF: press [MODE] (POWER) again for more than
2 seconds on the display unit.
Press [PWR] again or [MODE] again for more
than 2 seconds on the remote control.
Source selection (Mode)
Press [MODE] to change the mode.
OPEN / CLOSE
TV
DVD/VCD (Video CD)/CD/MP3
SD-Card (MPEG4/MP3/AAC/JPEG)
Radio(AM/FM)
VTR1
VTR2
CH-C (CD Changer Control)*
* Selectable only when a CD changer is connected.
Mode change on the Touch Panel
Touch A and then touch a symbol in the
Volume
Down
[ } ] (VOLUME) : up
[ { ] (VOLUME) : down
(on the remote control)
Setting Range:
–82 dB to 0 dB
default:
– 40 dB
(CQ-VD7700U)
Note: The sound level for each source is stored in memory.
Mute
MUTE ON: press [MUTE].
MUTE OFF: press [MUTE] again.
Display Open/Close
OPEN: press [ ] (OPEN/CLOSE).
CLOSE: press [
(After returning the lateral angle to the
neutral position.)
Notes:
(a page 36)
¡ When the display unit is opened or closed, a loud beep
sounds three times.
(a page 38, 42)
¡ If the unit stops halfway, press [
to draw it all the way in.
(a page 50)
¡ Opening/closing the display can be done when the power
is off.
(a page 46)
Warning: Do not touch the unit while the display
(a page 37)
is moving. Inserting hands, fingers or foreign
objects into the unit can cause injuries and
(a page 37)
damage to the unit.
(a page 48)
B .
Tilt Angle
q
Press and hold [TILT] on the display unit for more
than 2 seconds.
Up
or w
Press []] or [[] to adjust. Setup is the same as
from MENU. Refer to "MENU: User Settings" for
details.
Notes:
¡ Vertical angle (TILT) is saved in the memory, so when the
0 to 40 (step) display unit is drawn out next, it is automatically set at
the angle and in the position adjusted before.
18 (step) ¡ After adjusting its angle, also adjust the brightness to
(CQ-VD7500U) make it easy for you to watch. (
¡ The car model and installation conditions may impose
some restrictions on the adjustment of the monitor's
angle.
Folding Down the Display
Temporarily
Fold Down: press [TILT] on the display unit.
Raise: press [TILT] again on the display unit.
] (OPEN/CLOSE) again.
] (OPEN/CLOSE) again
Note: Even when the unit power is off, you can fold down
the display te mporarily.
Cautions:
¡ Avoid physical shock to the monitor.
¡ Do not place any object on the display unit, or subject
it to undue force.
¡ Do not move the display forcibly.
¡ The monitor movable range may be limited by the type of
car, a position where the display is mounted, etc.
E
N
G
L
I
S
H
19
(a page 54)
a page 58)
35
CQ-VD7700U/VD7500U