DRIVE WHEEL
NOTE: Refer to the current parts diagram for the current part number.
To replace the drive wheel:
1)
Remove the key from the key switch.
2)
Place the scooter in drive mode.
3)
Lift the scooter so that the wheel is off of the ground at least 2 inches.
4)
Place a support under the scooter frame.
5)
Remove the nut that fastens the drive wheel to the axle. See figure 3.
6)
Remove the drive wheel from the axle.
NOTE: Retain the axle key.
7)
Install the new drive wheel. Make sure the axle key is installed properly.
8)
Tighten the nut securely.
WWW.GOLDENTECH.COM
Figure 3. Drive Wheel
info@goldentech.com
PAGE - 17