Table of Contents
Advertisement
11) Unplug the brake harness (PH10) from the controller. Are the pins on PH10 seated
correctly?
•
Yes? – Go to the next step.
•
No? – Reseat the pins, reconnect the power harness to the controller, and try to run the scooter.
12) Measure resistance across pin 1(orange wire) and pin 2 (blue wire) on brake harness (PH10.)
•
Less than 80 ohms but not shorted? - Replace the controller.
•
Out of range? - Replace the power harness.
FLASH CODE #6 - PADDLE FAULT (OUT OF NEUTRAL)
1)
Remove the key from the key switch.
2)
Make sure that the paddle pot is not obstructed and it can return to the neutral (center) position..
3)
Move the throttle pot forward and then reverse. Make sure that it is not obstructed. Does it spring back to
neutral position?
•
Yes? – Go to the next step.
•
No? – Check for obstructions. Replace if there are no obstructions.
4)
Insert the key switch. Does the code return?
•
No? – OK
•
Yes? – Go to FLASH CODE
FLASH CODE #7 - PADDLE FAULT/SPEED CONTROL FAULT (VOLTAGE ERROR.)
1)
Make sure that the batteries are fully charged.
2)
Remove the battery box.
3)
Remove the battery box lid.
4)
Reinstall the battery box onto the scooter frame.
5)
Open the front console.
6)
Insert the key into the key switch.
7)
Insert the positive lead (red) from the multimeter into the back of pin 6 (yellow wire) on the main harness
(MH2.) NOTE: It may be necessary to insert a straightened paper clip in order to get a good connection.
8)
Connect the negative lead (black) from the multimeter to BAT-. Use the BAT- terminal that is connected to
ICH2. Measure voltage.
•
Approximately 2.5VDC? – Go to step 12.
•
Out of range? – Go to the next step.
9)
Disconnect the paddle pot from the console board. Check the yellow connector on the console board.
Is it loose?
•
Yes? – Replace the console board.
•
No? – Go to the next step.
10) Are the pins on the connectors seated correctly?
•
Yes? – Go to the next step.
•
No? – Reseat the pins, reconnect the paddle pot to the console board, and try to run the scooter.
11) Measure resistance across pin 1 (blue wire) and pin 2 (yellow wire) on the paddle pot connector.
•
Approximately 2.7k ohms? – Go to the next step.
•
Out of range? – Replace the paddle pot.
12) Measure resistance across pin 2 (yellow wire) and pin 3 (orange wire) on the paddle pot connector.
•
Approximately 2.7k ohms? – Replace the console board.
•
Out of range? – Replace the paddle pot.
WWW.GOLDENTECH.COM
#7
to test the paddle pot.
info@goldentech.com
PAGE - 14
Hide quick links:
Advertisement
Table of Contents
