Makita HS6100 Technical Information page 9

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -5. Blade Case, Blade Cover, Safety Cover
DISASSEMBLING
(5) Remove Blade cover as described in Fig. 9.
Fig. 9
1. Remove two M4x12
Pan head screws.
Blade case
Blade cover
ASSEMBLING
(1) Mount Bearing box on Blade case. (See the right illustration in Fig. 8.)
(2) Mount Tension spring 4 on Blade case and Safety cover as described in Fig. 10.
Fig. 10
Blade side
(3) Set Retaining ring S-42 in place with 1R003. (See the left illustration in Fig. 8)
(4) Take the reverse step of Disassembling. (Fig. 7)
2. Grab Blade cover at the tab and the bottom
with your forefinger and thumb, then lift it
up a little and put the rib portion of Blade
case on the edge of Blade case.
tab
rib portion,
put on the edge
of Blade case
Insert the hook from Blade side to Motor housing side.
Insert the hook from Motor housing side to Blade side.
3. Pull off Blade cover from
Blade case
Tension spring 4
Motor housing side
Safety cover
P 9/16
Blade case by sliding it
in the direction of the arrow.