Makita HS6100 Technical Information page 8

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -5. Blade Case, Blade Cover, Safety Cover
DISASSEMBLING
(1) Separate Motor housing and Armature from Blade case section as described in Fig. 7.
Fig. 7
1. Remove Carbon brush.
Brush holder
cap
Carbon brush
3. Separate Motor housing from Blade case section.
Rubber washer 13
Note:
If Rubber washer 13 falls off Motor housing in this step,
put it back into Bearing box of Motor housing.
(2) Remove both Angular guide section and Rear angular guide section from Base. (Fig. 2)
(3) Remove Depth guide and M6x8 Hex bolt from Blade case. (Fig. 4)
(4) Remove Safety cover together with Tension spring 4, Bearing box and other parts from Blade case. (Fig. 8)
Fig. 8
Tension spring 4
Safety cover
Retaining ring S-42
Use 1R003 for removing Retaining ring S-42.
Brush holder
cap
2. Remove three M5x45 Pan head screws.
4. Remove Armature together with Shaft lock
and Compression spring 7.
Shaft lock
M5x8 Hex socket
set screw
Bearing box
M5x16
Pan head screw
P 8/16
Compression spring 7
Armature
O Ring 44
Rubber sleeve 6
M6x20 Pan head screw