Makita HS6100 Technical Information page 11

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -7. Handle Cover, Electrical Parts in Handle
DISASSEMBLING
Remove Handle cover from Motor housing as described in Fig. 14.
Note: No need to disassemble Blade case or Motor housing.
Fig. 14
1. Lift up Handle cover
in the direction of arrow
[4] ADJUSTMENT
[4]-1 Angle of Saw Blade to Base
(1) Attach Saw blade to the unplugged machine, and set to the cutting depth to maximum.
(2) Adjust the angle of saw blade to Base as described in Fig. 15.
Fig. 15
[Adjustment to 90 degrees]
1. Set the cutting depth of the machine to maximum
with the bevel angle adjusted to 90 degrees.
2. Tighten Lever 45, Lever 70 and M6 Thumb nut.
3. Open Safety cover fully, then apply 1R208 to
the base metal of the saw blade as drawn below,
Then adjust for 90 degree accuracy by turning
M6x8 Hex socket set screw with hex wrench.
1R208
2. Turn Handle cover
. in the direction of arrow
Then pull the Handle cover
in the direction of arrow
3. Electrical parts (Switch, Power supply cord,
. LED light circuit, Controller etc.) can now
be replaced.
.
LED light circuit
[Adjustment to 45 degrees]
1. Set the cutting depth of the machine to maximum
with the bevel angle adjusted to 45 degrees.
2. Tighten Lever 45, Lever 70 and M6 Thumb nut.
3. Open Safety cover fully, then apply 1R207 to
the base metal of the saw blade as drawn below,
Then adjust for 45 degree accuracy by turning
M6x8 Hex socket set screw with hex wrench.
P 11/16
Power supply
cord
Switch
1R207