System Board Removal And Replacement Procedure - HP ProLiant DL165 G7 Maintenance And Service Manual

System board removal and replacement procedure

To remove the system board:
Remove the top cover.
1.
Remove the air baffle and all cables from the system board.
2.
Loosen the nine screws that secure the system board to the chassis.
3.
Slide the system board back, up and out of the chassis. Remove the system board from the
4.
chassis.
Figure 76
Removing the System Board
NOTE: Extreme care must be taken to ensure the system board components on the bottom of the
system board not be scraped or dislodged by the screw standoffs. The sliding action requires that
the rear panel should be cleared slightly and the front of the system board should be raised slightly
as you move the system board towards the front and up.
Removal and replacement procedures 84