Table of Contents
Advertisement
To engage a PTO with Stationary Variable:
1. Make sure the vehicle is stopped.
2. Shift the transmission into NEUTRAL (N) or
PARK (P), if equipped.
3. The brake or clutch pedal must be pressed and
released once before PTO can be enabled. Do not
hold the brake or clutch pedal down.
4. The PTO Enable and cruise control (if equipped)
switch must be in ON.
5. Press the accelerator pedal to the desired rpm.
6. Rpm settings are controlled by the multifunctional
stalk lever.
A. OFF/ON: ON position holds rpm selected by
the accelerator pedal.
B. With the optional cruise control:
RESUME/ACCEL increases by 25 rpm.
SET/COAST decreases by 25 rpm.
C. Without the optional cruise control: PTO UP
increases by 25 rpm. PTO DOWN decreases
by 25 rpm.
4-32
To engage a PTO with Mobile Variable:
1. The PTO Enable and cruise control (if equipped)
switch must be in ON.
2. Press the accelerator pedal to the desired
engine speed.
3. Engine speed is controlled by the multifunctional
stalk lever.
A. OFF/ON: ON position holds engine speed
selected by the accelerator pedal.
B. With the optional cruise control:
RESUME/ACCEL increases by 25 rpm.
SET/COAST decreases by 25 rpm.
C. Without the optional cruise control: PTO UP
increases by 25 rpm. PTO DOWN decreases
by 25 rpm.
The PTO will become inoperative when any of the
conditions are changed, the brake pedal is pressed or
the switch is turned off.
For more information regarding the PTO settings please
see your GM dealer for assistance.
Advertisement
Table of Contents
