Table of Contents
Advertisement
Power Take
Off (PTO) (If Equipped)
-
Before using a PTO, refer to the manufacturer's or
installer's instructions.
To engage a PTO with Stationary Preset:
1. Make sure the vehicle is stopped.
2. Shift the transmission into NEUTRAL (N) or
PARK (P), if equipped.
3. The brake or clutch pedal must be pressed and
released once before PTO can be enabled. Do not
hold the brake or clutch pedal down.
4. The PTO Enable
A. OFF/ON: ON position has a base engine idle
of 1,400 rpm.
B. With optional cruise control: RESUME/ACCEL
has a base engine idle of 1,800 rpm. SET/COAST
has a base engine idle of 1,400 rpm.
C. Without optional cruise control: PTO UP has a
base engine idle of 1,800 rpm. PTO DOWN has
a base engine idle of 1,400 rpm.
and cruise control
(if equipped)
switch must be
in ON prior to
enabling the PTO
operation. Three
rpm settings are
controlled by the
multifunctional
stalk lever.
4-31
Advertisement
Table of Contents
