Table of Contents
Advertisement
Table 38 Expert > LAN > LAN IP (continued)
LABEL
DHCP Server
IP Pool Starting
Address
Pool Size
Apply
Cancel
12.5 Static DHCP Screen
This screen allows you to assign IP addresses on the LAN to specific individual computers based on
their MAC addresses.
To change your ARMOR Z1's static DHCP settings, click Expert > LAN > Static DHCP.
Figure 67 Expert > LAN > Static DHCP
The following table describes the labels on this screen.
Table 39 Expert > LAN > Static DHCP
LABEL
#
MAC Address
IP Address
Apply
Cancel
Chapter 12 LAN
DESCRIPTION
Select Enable to activate DHCP for LAN.
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows
individual clients (computers) to obtain TCP/IP configuration at startup from a server.
Enable the DHCP server unless your ISP instructs you to do otherwise. Select Disable
to stop the ARMOR Z1 acting as a DHCP server. When configured as a server, the
ARMOR Z1 provides TCP/IP configuration for the clients. If not, DHCP service is
disabled and you must have another DHCP server on your LAN, or else the computers
must be manually configured. When set as a server, fill in the following four fields.
This field specifies the first of the contiguous addresses in the IP address pool for LAN.
This field specifies the size, or count of the IP address pool for LAN.
Click Apply to save your changes back to the ARMOR Z1.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
This is the index number of the static IP table entry (row).
Type the MAC address (with colons) of a computer on your LAN.
Type the LAN IP address of a computer on your LAN.
Click Apply to save your changes with the ARMOR Z1.
Click Cancel to begin configuring this screen afresh.
ARMOR Z1 User's Guide
104
Advertisement
Table of Contents
