Number) in the devices. Then, they connect and set up a secure network by themselves. See how
to set up a secure wireless network using WPS in the
11.2 Wireless Screen
Use this screen to configure the SSID and wireless security of the ARMOR Z1's default wireless LAN.
Note: If you are configuring the ARMOR Z1 from a computer connected to the wireless
LAN and you change the ARMOR Z1's SSID, channel or security settings, you will
lose your wireless connection when you press Apply to confirm. You must then
change the wireless settings of your computer to match the ARMOR Z1's new
settings.
Click Expert > Wireless.
Figure 54 Expert > Wireless
The following table describes the general wireless LAN labels in this screen.
Table 28 Expert > Wireless
LABEL
Wireless Setup
Band
Wireless LAN
Chapter 11 Wireless LAN
DESCRIPTION
Select the frequency band to set whether you want to apply the wireless and security
settings to the default 2.4GHz or 5GHz wireless LAN.
Select Enable to activate the 2.4GHz and/or 5GHz wireless LAN. Select Disable to turn it
off.
You can enable or disable both 2.4GHz and 5GHz wireless LANs by using the WIFI button
located on the back panel of the ARMOR Z1.
ARMOR Z1 User's Guide
Section 8.2 on page
88
49.