Table of Contents
Advertisement
Table 58 Expert > Maintenance > Backup/Restore (continued)
LABEL
Upload
Reset
Note: If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default ARMOR
Z1 IP address (192.168.1.1). See
up your computer's IP address.
15.8 Restart Screen
System restart allows you to reboot the ARMOR Z1 without turning the power off.
Click Expert > Maintenance > Restart to open the following screen.
Figure 94 Expert > Maintenance > Restart
Click Restart to have the ARMOR Z1 reboot. This does not affect the ARMOR Z1's configuration.
15.9 Language Screen
Use this screen to change the language for the Web Configurator.
Select the language you prefer and click Apply. The Web Configurator language changes after a
while without restarting the ARMOR Z1. Click Expert > Maintenance > Language to open the
following screen.
Chapter 15 Maintenance
DESCRIPTION
Click Upload to begin the upload process.
Note: Do not turn off the ARMOR Z1 while configuration file upload is in progress.
After you see a "configuration upload successful" screen, you must then wait one minute
before logging into the ARMOR Z1 again. The ARMOR Z1 automatically restarts in this time
causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Pressing the Reset button in this section clears all user-entered configuration information
and returns the ARMOR Z1 to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your
ARMOR Z1. Refer to the chapter about introducing the Web Configurator for more
information on the RESET button.
ARMOR Z1 User's Guide
Appendix C on page 173
143
for details on how to set
Advertisement
Table of Contents
