GMC 2008 Yukon Denali Owner's Manual page 242

EQ (Equalization): Press to change Digital Signal
Processing (DSP) settings (Bose
DSP settings provide a choice of different listening
experiences.
The following DSP settings are available:
•
Normal — Select this setting to adjust the audio for
normal mode. This provides the best sound quality
for all seating positions.
•
Driver — Select this setting to adjust the audio for
the driver to receive the best possible sound
quality.
•
Rear — Select this setting to adjust the audio for
the rear seat passengers to receive the best
possible sound quality.
•
Surround (Centerpoint
enable Bose Centerpoint
processing produces a surround sound listening
experience from a CD or XM™ stereo digital audio
source. Centerpoint
audio channels from conventional two channel
stereo recordings. (Not available for AM, FM.)
3-80
®
audio systems only).
®
) — Select this setting to
® ®
. Centerpoint signal
®
delivers five independent
Adjusting the Speakers (Balance/Fade)
BAL/FADE (Balance/Fade): To adjust balance or
f
fade, press the knob until the speaker control labels
display. Continue pressing to highlight the desired
label, or press the pushbutton positioned under the
f
desired label. Turn the
counterclockwise to adjust the highlighted setting. The
highlighted setting can also be adjusted by pressing
either SEEK arrow, \
the desired levels are obtained.
To quickly adjust balance or fade to the middle position,
press the pushbutton positioned under the BAL or
FADE label for more than two seconds. A beep sounds
and the level adjusts to the middle position.
To quickly adjust all speaker and tone controls to the
middle position, press the
two seconds.
knob clockwise or
FWD, or s REV button until
f
knob for more than