Cruise Control - GMC 2008 Yukon Denali Owner's Manual

Hide thumbs Also See for 2008 Yukon Denali:
Table of Contents

Advertisement

=
(Rear Wiper Wash): To turn on the rear wiper
wash, push the button on the end of the turn
signal/multifunction lever to spray washer fluid on the
rear window. The wipers will clear the rear window and
either stop or return to your preset speed. For more
washer cycles, press and hold the button.
The rear window wiper/washer will not operate if the
liftgate or liftglass is open or ajar. If the liftgate or
liftglass is opened while the rear wiper is on, the wiper
will return to the parked position and stop.

Cruise Control

CAUTION:
{
Cruise control can be dangerous where you
cannot drive safely at a steady speed. So, do
not use your cruise control on winding roads
or in heavy traffic.
Cruise control can be dangerous on slippery
roads. On such roads, fast changes in tire
traction can cause excessive wheel slip, and
you could lose control. Do not use cruise
control on slippery roads.
With cruise control, a speed of about 25 mph (40 km/h)
or more can be maintained without keeping your foot
on the accelerator. This can really help on long
trips. Cruise control does not work at speeds below
about 25 mph (40 km/h).
When the brakes are applied, the cruise control
turns off.
If your vehicle has the StabiliTrak
to limit wheel spin while you are using cruise control, the
cruise control will automatically disengage. See
®
StabiliTrak
System on page 4-6. When road conditions
allow you to safely use it again, you may turn the
cruise control back on.
®
system and begins
3-13

Advertisement

Table of Contents
loading

This manual is also suitable for:

2008 yukon xl denali

Table of Contents