Remove The K-Board - Panasonic TH-50PX60U Service Manual

TH-50PX60U

6.29. Remove the K-Board

1. Unlock the cable clampers to free the cable.
2. Disconnect the couplers (G1 and S1). (See section 6.25.
and 6.28.)
3. Remove the screws (×2
6.30. Remove the Plasma panel
section from the Front frame
(glass)
1. Remove the front frame and the plasma panel fastening
screws (×6 ).
2. Remove the front frame and the stand brackets fastening
screws (×4 ).
3. For leaving the plasma panel from the front frame, pull the
bottom of the front frame forward, lift, and remove.
) and remove the K-Board.
6.31. Replace the plasma panel
(finished)
1. Place the new plasma panel (finished) on the flat surface of
the table (covered by a soft cloth), with the plasma panel
surface facing downward.
2. Attach the C1, C2, C3, C4, C5 and the C6-Board, connect
the flexible cables (×22) from the Plasma panel to the C1,
C2, C3, C4, C5 and the C6-Board, and fit the flexible cable
holders.
3. Attach the Hooks (left, right) and fit the stand brackets (L,
R) to the new plasma panel.
4. Place the plasma panel section on the servicing stand.
5. Attach the front frame and each P.C.Board and so on, to
the new plasma panel.
* When fitting the front frame, be careful to allow any
debris, dust or handling residue to remain between the
front glass and plasma panel.
16