Table of Contents
Advertisement
8 Disassembly and Assembly Instructions
8.1.
Remove the Rear cover
1. See PCB Layout (Section 3)
8.2.
Remove the AC inlet
Caution:
To remove P.C.B. wait 1 minute after power was off for dis-
charge from electrolysis capacitors.
1. Unlock the cable clampers to free the cable.
2. Disconnect the connector (P9).
3. Remove the screws (×2
4. Remove the screw (×1
8.3.
Remove the P-Board
Caution:
To remove P.C.B. wait 1 minute after power was off for dis-
charge from electrolysis capacitors.
1. Unlock the cable clampers to free the cable
2. Disconnect the connectors (P2, P6, P11, P34 and P35).
3. Remove the screws (×5
) and remove the Inlet metal.
) and remove the AC inlet.
) and remove the P-Board.
8.4.
Remove
cover and the shield metals
1. Remove the claw (×1
2. Remove the Side terminal cover.
3. Remove the screws (×2
4. Remove the Bottom shield metal.
5. Remove the screw (×1
6. Remove the Side shield metal.
8.5.
Remove the A-Board
1. Remove the Side terminal cover and the Shield metals.
(See section 8.4.)
2. Unlock the cable clampers to free the cable.
3. Disconnect the connectors (A1, A6, A8, A11 and A14).
4. Disconnect the flexible cables (A20, A31, A32 and A40).
5. Remove the screw (×1
21
the
Side
terminal
).
).
).
) and remove the A-Board.
Advertisement
Table of Contents
