TH-50PX60U
6.21. Remove the stand brackets
1. Remove the plasma panel section from the servicing stand
and lay on a fiat surface such as a table (covered) with the
plasma panel surface facing downward.
2. Remove the stand brackets (left, right) fastening screws (×6
each) and remove the stand brackets (left, right).
6.22. Remove the C4-Board
1. Remove the stand bracket (left). (See section 6.21.)
2. Remove the flexible cables holder fastening screws (×8
).
3. Disconnect the flexible cables (CB8, CB9, CB10 and
CB11).
4. Disconnect the flexible cables (C41 and C42).
5. Disconnect the couplers (C43 and C44).
6. Remove the screws (×5
) and remove the C4-Board.
6.23. Remove the C5-Board
1. Remove the flexible cables holder fastening screws (×8
).
2. Disconnect the flexible cables (CB4, CB5, CB6 and CB7).
3. Disconnect the flexible cables (C50, C51 and C52).
4. Remove the screws (×5
6.24. Remove the C6-Board
1. Remove the stand bracket (right). (See section 6.21.)
2. Remove the flexible cables holder fastening screws (×6
).
3. Disconnect the flexible cables (CB1, CB2 and CB3).
4. Disconnect the flexible cable (C60).
5. Remove the screws (×5
14
) and remove the C5-Board.
) and remove the C6-Board.