Remove The Hanger Metals And The Stand Brackets; Remove The C1-Board; Remove The C2-Board; Remove The C3-Board - Panasonic TH-P54S10M Service Manual

8.14. Remove the Hanger metals and
the Stand brackets
1. Remove the Plasma panel section from the servicing
stand and lay on a flat surface such as a table (covered
by a soft cloth) with the Plasma panel surface facing
downward.
2. Remove the Hanger metals (L, R) fastening screws (×4
each) and remove the Hanger metals (L, R).
3. Remove the Stand brackets (L, R) fastening screws (×4
each) and the Stand brackets (L, R).

8.15. Remove the C1-Board

1. Remove the Control button unit. (See section 8.7.)
2. Remove the Hanger metal R and the Stand bracket R.
(See section 8.14.)
3. Remove the flexible cables holder fastening screws (×10
).
4. Disconnect the flexible cables (CB1, CB2, CB3, CB4 and
CB5).
5. Disconnect the flexible cable (C10).
6. Disconnect the connector (C14).
7. Remove the screws (×4

8.16. Remove the C2-Board

1. Remove the flexible cables holder fastening screws (×10
).
2. Disconnect the flexible cables (CB6, CB7, CB8, CB9 and
CB10).
3. Disconnect the flexible cables (C20, C21, C22 and C26).
4. Remove the screws (×4

8.17. Remove the C3-Board

1. Remove the Tuner unit. (See section 8.4.)
2. Remove the Hanger metal L and the Stand bracket L.
(See section 8.14.)
3. Remove the flexible cables holder fastening screws (×10
).
4. Disconnect the flexible cables (CB11, CB12, CB13, CB14
and CB15).
5. Disconnect the flexible cable (C36).
6. Disconnect the connectors (C33 and C35).
7. Remove the screws (×5
24
) and remove the C1-Board.
) and remove the C2-Board.
) and remove the C3-Board.