Makita AF500HP Technical Information page 10

R
epair
[4] DISASSEMBLY/ASSEMBLY
[4]-6 Magazine (cont.)
DISASSEMBLING
Fig. 26
Nail guide
holder
Nail stopper
(7pcs.)
Tilting Nail guide holder together with
Nail stoppers as illustrated above,
remove them while holding Compression
spring 4.
Fig. 27
Nail stopper (7pcs.)
Nail guide holder
Nail stoppers can be removed
by pulling in the direction
designated with black arrows.
ASSEMBLING
Take the disassembling step in reverse while paying attention to the following matters.
* Be sure to set two Washers in place when screwing M3 Hex socket head screw to Magazine. Refer to Fig. 22.
* Before assembling Pusher, pass Guide pipe through Joint. Refer to Fig. 24.
Compression
spring 4 (7pcs.)
If Nail stopper is violently pulled off from the Compression
spring 4, the Compression spring is deformed, or springs out
of Slide door cap.
Fig. 28
1R032
Remove Spring pin 3-28 (2 pcs.) with 1R268 and 1R032.
Magazine bumper can be disassembled from Slide door cap.
Compression spring 4
Nail stopper
Slide door cap
Nail stopper
Compression spring 4
Slide door cap
Tilt Nail stopper as illustrated above.
Nail stopper can be smoothly pulled off without
deforming or losing Compression spring 4 .
Magazine bumper
1R268
Spring pin 3-28
P 10/ 14
Slide door cap