Residual Risks - Black & Decker BDCD8 Original Instructions Manual

ENGLISH
concerning use of the tool by a person
responsible for their safety.
♦ Children should be supervised to ensure that
they do not play with the appliance.

Residual risks

Additional residual risks may arise when using the
tool which may not be included in the enclosed
safety warnings. These risks can arise from
misuse, prolonged use etc.
Even with the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks can not be avoided.
These include:
♦ Injuries caused by touching any rotating/
moving parts.
♦ Injuries caused when changing any parts,
blades or accessories.
♦ Injuries caused by prolonged use of a tool.
When using any tool for prolonged periods
ensure you take regular breaks.
♦ Impairment of hearing.
♦ Health hazards caused by breathing dust
developed when using your tool (example:-
working with wood, especially oak, beech and
MDF.)
Vibration
The declared vibration emission values stated
in the technical data and the declaration of
conformity have been measured in accordance
with a standard test method provided by EN 60745
and may be used for comparing one tool with
another. The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
Warning! The vibration emission value during
actual use of the power tool can differ from the
declared value depending on the ways in which
the tool is used. The vibration level may increase
above the level stated.
When assessing vibration exposure to determine
safety measures required by 2002/44/EC to
protect persons regularly using power tools in
employment, an estimation of vibration exposure
should consider, the actual conditions of use and
the way the tool is used, including taking account
of all parts of the operating cycle such as the
times when the tool is switched off and when it is
running idle in addition to the trigger time.
Labels on tool
The following symbols are shown on the tool
along with the date code:
6
Warning! To reduce the risk of injury, the
user must read the instruction manual.
Additional safety instructions for
batteries and chargers (Not provided
with the tool)
Batteries
♦ Never attempt to open for any reason.
♦ Do not expose the battery to water.
♦ Do not store in locations where the
temperature may exceed 40 °C.
♦ Charge only at ambient temperatures between
10 °C and 40 °C.
♦ Charge only using the charger provided with
the tool.
♦ When disposing of batteries, follow the
instructions given in the section "Protecting
the environment".
Do not attempt to charge damaged
batteries.
Chargers
♦ Use your BLACK+DECKER charger only to
charge the battery in the tool with which it was
supplied. Other batteries could burst, causing
personal injury and damage.
♦ Never attempt to charge non-rechargeable
batteries.
♦ Have defective cords replaced immediately.
♦ Do not expose the charger to water.
♦ Do not open the charger.
♦ Do not probe the charger.
Ładowarka nie jest d The charger
is intended for indoor use only.
opuszczona do pracy na wolnym
powietrzu!
Read the instruction manual before use.
Electrical safety
Your charger is double insulated; therefore
no earth wire is required. Always check
that the mains voltage corresponds to the
voltage on the rating plate. Never attempt
to replace the charger unit with a regular
mains plug.
♦ If the supply cord is damaged, it must be
replaced by the manufacturer or an authorised
BLACK+DECKER Service Centre in order to
avoid a hazard.