Troubleshooting; Maintenance; Protecting The Environment - Black & Decker BDCD8 Original Instructions Manual

ENGLISH
♦ Use a block of wood to back up workpieces
that may splinter.
♦ Use spade bits when drilling large diameter
holes in wood.
♦ Use HSS drill bits when drilling in metal.
♦ Use masonry bits when drilling in soft
masonry.
♦ Use a lubricant when drilling metals other than
cast iron and brass.
♦ Make an indentation using a centre punch at
the centre of the hole to be drilled in order to
improve accuracy.
Screwdriving
♦ Always use the correct type and size of
screwdriver bit.
♦ If screws are diffi cult to tighten, try applying
a small amount of washing liquid or soap as
a lubricant.
♦ Always hold the tool and screwdriver bit in
a straight line with the screw

Troubleshooting

Problem Possible cause
Unit will not start. Battery pack not
charged.
Battery pack will Charger not
not charge. plugged in.
Surrounding air
temperature too hot
or too cold.

Maintenance

Your BLACK+DECKER tool has been designed to
operate over a long period of time with a minimum
of maintenance.
Continuous satisfactory operation depends upon
proper tool care and regular cleaning.
Your charger does not require any maintenance
apart from regular cleaning.
Warning! Before performing any maintenance on
the tool, remove the battery from the tool. Unplug
the charger before cleaning it.
♦ Regularly clean the ventilation slots in your
tool and charger using a soft brush or dry
cloth.
♦ Regularly clean the motor housing using
a damp cloth.
8
Do not use any abrasive or solvent-based
cleaner.
♦ Regularly open the chuck and tap it to remove
any dust from the interior.

Protecting the environment

Should you fi nd one day that your
BLACK+DECKER product needs replacement, or
if it is of no further use to you, do not dispose of it
with household waste. Make this product available
for separate collection.
Local regulations may provide for separate
collection of electrical products from the
Possible solution
household, at municipal waste sites or by the
Check battery
retailer when you purchase a new product.
pack charging
requirements
BLACK+DECKER provides a facility for the
Plug charger into
collection and recycling of BLACK+DECKER
a working outlet.
products once they have reached the end of their
Move charger and
working life. To take advantage of this service
battery pack to
please return your product to any authorised
a surrounding air
repair agent who will collect them on our behalf.
temperature of
above 40 degrees
You can check the location of your nearest
F (45ºC) or below
105 degrees F
authorised repair agent by contacting your local
(+40.5ºC)
BLACK+DECKER offi ce at the address indicated
in this manual. Alternatively, a list of authorised
BLACK+DECKER repair agents and full details of
our after-sales service and contacts are available
on the Internet at: www.2helpU.com
Batteries
♦ At the end of your products life return the
whole unit to your service agent or to a local
recycling station to have the battery recycled.
Do not throw the unit out with household
waste.
Separate collection. This product must
not be disposed of with normal household
waste.
Separate collection of used products and
packaging allows materials to be recycled
and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the
demand for raw materials.
There are no user servicable parts inside.