Viewing On Tv Screen - Panasonic DVD Palmcorder VDR-M30PP Instruction Manual

Viewing on TV Screen

1
Turn on the TV and set the input selector to the
Input connection the DVD Palmcorder is
connected to. This is often refered to as "line".
Refer to the TV instruction manual for how to
switch the TV input.
2
Turn the DVD Palmcorder on.
The image that the DVD Palmcorder is viewing
will appear on the TV screen.
You can also monitor the image on the LCD
screen or viewfinder of the DVD Palmcorder.
3
Perform playback, recording or editing.
You can perform playback, editing or editing on
Disc Navigation while checking on TV screen.
:
Note
•
Adjust the volume of sound on TV.
•
The infrared remote controller is useful when operating
the DVD Palmcorder while viewing an image on TV
screen. However, if you use a Panasonic VCR, the
remote controller may inadvertently operate the VCR if it
is near the DVD Palmcorder. To prevent this, set the
remote control code of the VCR to a position other than
"VCR2".
•
Information that the DVD Palmcorder is recording will
appear on the TV screen: You can also display only part
of information or switch off the display. Refer to "Setting
OSD Output On or Off (On-Screen Display)" on page 92,
and press the DISPLAY button to switch the display
status.
•
When copy-guarded disc is played back, no image will
appear on TV screen.
•
If you use TV with wide mode (aspect ratio 16:9) and set
the TV to the wide mode, the entire Disc Navigation
display may not be displayed on the TV screen. If this
happens, release the wide mode setting on TV (see the
TV instruction manual for releasing the wide mode).
75