Panasonic DVD Palmcorder VDR-M30PP Instruction Manual page 160

When the DVD Palmcorder is connected to PC:
Symptom
No drive icon appears on
PC.
A fatal exception 0A error
occurs while installing
USB driver in Windows
2000 Professional.
Error occurs in playback
of DVD Palmcorder on
PC.
Application is not
normally run on PC.
Error occurs during
writing to DVD-R disc.
Transfer of images stops. Connect the DVD Palmcorder to another USB terminal of PC. If your
DVD-RAM/R/RW drive
built into PC cannot be
used after the provided
software has been
installed.
DVD-R disc cannot be
played back on DVD-
MovieAlbumSE.
Error appears when
starting DVD-
MovieAlbumSE.
Video written to hard disk
of PC cannot be edited
on DVD-MovieAlbum
copy tool.
160
The DVD Palmcorder is not turned on.
Check the power supply.
Driver is not properly recognized.
Turn PC off and on again. If the drive icon still does not appear, use
"Refresh driver" in Device Manager to reinstall the driver.
Turn PC off and then disconnect the USB cable. Turn PC on again,
and then use the USB cable to connect the DVD Palmcorder to PC.
Make sure the USB cable is completely plugged into this DVD
Palmcorder.
If a yellow "!" mark is attached to some device in Windows
Manager, uninstall the USB device driver, and then reinstall it,
following the procedure on page 137.
It is recommended that you install Windows
or later.
®
If error occurs with USB connection, the transfer rate is not sufficient.
It is recommended that you use a USB terminal conforming to
USB2.0 when connecting the DVD Palmcorder.
Turn the PC and DVD Palmcorder off, and try again.
The temperature of DVD Palmcorder is too high due to continuous
operation.
Disconnect the DVD Palmcorder from PC once, remove the disc
from the DVD Palmcorder, and then turn it off. After a few moments,
connect them again and write to a brand-new disc.
PC is a desktop type, it is recommended that you use USB terminal
on the back of PC. If you are using USB2.0 extended card, it is also
recommended that you install the newest version driver provided by
each USB2.0 card maker.
This problem may be solved if the software related to DVD-RAM/R/
RW of your PC is upgraded, or if the UDF driver is uninstalled.
However, with Windows
Professional, uninstalling the UDF driver will make it impossible for
the JPEG stills recorded on DVD-RAM of this DVD Palmcorder to be
read by the PC.
DVD-MovieAlbumSE does not support playback or data read on
DVD-R disc: Use generally available DVD video playback software
to play back DVD-R disc on PC.
Make sure that your PC display adapter (video card) conforms to
DirectX8.1.
DVD-MovieAlbumSE cannot edit DVD-VR data stored on hard disk
of PC: Copy the data to another DVD-RAM disc and then edit it.
Cause and Correction
®
®
98 Second Edition / Me / 2000
®
Device
2000 Service Pack 3
Reference
page
47










142

