Audio Dubbing - Panasonic DVC20 Operating Instructions Manual

DVC20_Eng.book 29 ページ ２００５年１０月３１日 月曜日 午前１０時３６分

Audio dubbing

You can add music or narration to the recorded cassette.
≥Set to Tape Playback Mode.
1
Insert an external microphone securely into the
[EXT MIC] terminal as far as it will go.
2
Find a scene that you want to add sound to, and press
the [;] button on the remote control.
V W
/REW PLAY FF/
W
VOL
STILL ADV PAUSE STILL ADV
STOP
3
Press the [A.DUB] button on the remote control to make
audio dubbing ready.
ZOOM
T
¥
REC A.DUB
V /REW PLAY FF/ W
W
VOL
STILL ADV PAUSE STILL ADV
4
Press the [;] button on the remote control to start audio
dubbing.
V W
/REW PLAY FF/
W
VOL
STILL ADV PAUSE STILL ADV
STOP
≥Talk into the microphone.
5
Press the [;] button on the remote control to stop audio
dubbing.
V
/REW PLAY
STILL ADV PAUSE
STOP
≥If a tape has a non-recorded portion when the tape is dubbed,
images and sounds may be disturbed when this portion of the
tape is played back.
Edit mode
EXT MIC
;
A.DUB ;
A.DUB ¥
W
FF/
W
VOL
STILL ADV
ª Before recording with audio dubbing
≥Set to Tape Recording Mode.
≥When you want to preserve the original sound taken during
recording, set [SETUP] >> [AUDIO REC] >> [12bit] to take
pictures. (When set [16bit], the sounds taken during recording
are erased after recording with audio dubbing.)
≥Set [BASIC] >> [REC SPEED] >> [SP] to take pictures.
ª
To play back the sound recorded with audio
dubbing
You can switch between the sound recorded with audio
dubbing and the original sound.
Set [SETUP] >> [12bit AUDIO] >> [ST2] or [MIX].
[ST1]: It only plays back the original sound.
[ST2]: It only plays back the sound added by audio dubbing.
[MIX]: It simultaneously plays back the original sound and the
sound added with audio dubbing.
29