Table of Contents
Advertisement
Configure commands to execute for detection
You can specify executing commands for motion detection and/or alarm detection.
Specify the commands in their respective pages when you execute the commands
specified (see page 29, 32, 61).
Detection Commands Page
Setting
Commands for
Camera External
Output Settings
Optional Command
Controlling Command
Execution
* The Beep program is installed with this software.
"Beep 1000 1000" is a command that makes a beeping sound at 1000 Hz for 1000
ms. You can set user created commands as well.
However, depending on the command's operation, recording performance may be
affected. Use optional commands after thorough testing. Recorded image quality
cannot be guaranteed when using optional commands.
Set a command (Short to GND or Open) to execute at the
external equipment that is connected to the camera for
motion detection and/or alarm detection and an unlock time
for the specified command (see page 34).
Select optional commands to execute when motion or an
alarm is detected. Default is Beep 1000 1000*.
You can select Execute a command only once at the start of
recording, or you can specify a number of seconds during
which commands will not being executed after a command
has finished executing (see page 35).
Description
Operating Instructions
33
Advertisement
Table of Contents
