Makita BHS630 Technical Information page 4

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-2. Lock Lever
ASSEMBLING
Assemble Lock lever to Base, and adjust to obtain the convenient lock position as drawn in Fig. 4.
Fig. 4
1. Tighten M6x10 Hex bolt to fix Guide rule to Base.
Guide Rule
3. Set Lock lever to M6x10 Hex bolt, while hooking Torsion spring 11
with its long Arm to the Rib of Base.
Long arm of
Torsion spring 11
Lock lever
4. Push the Lock lever to engage it with M6x10 Hex bolt at the
convenient position for loosening and locking.
And secure the Lock lever with Stop ring E-6.
Stop ring E-6
M6x10 Hex bolt
Base
long arm of
Torsion spring 11
Lock lever
Rib
M6x10 Hex bolt
Lock lever
2. Set Torsion spring 11 to Lock lever
as drawn in below.
Long arm of
Torsion spring 11
Note:
Do not yet push Lock lever to the
position where it is in this step.
Otherwise, Lock lever engages
unintentionally with M6x10
Hex bolt, before obtaining the
convenient position for operating
Lock lever.
Rib
5. Make sure that the reassembled
Guide rule is locked with the
Lock lever at the same position.
Stop ring E-6
Lock lever
P 4/ 16