Unpacking; Hardware - Performax 240-3605 Operator's Manual

Refer to Figures 1a-1c.
This product requires assembly.
• Open shipping box. Remove all parts and saw body with leg stand assembly B from the box and separate the parts.
NOTE: This tool is heavy. To avoid back injury, keep your knees bent and lift with your legs, not your back, and get help
when needed.
• Place the saw body with leg stand assembly B on the cardboard or an old blanket on floor in order to protect the leg stand.
• Lay out the parts and check them against the parts as shown illustrations Fig. 1a-1c.
CAUTION: Do not attempt assembly if parts are missing. Use this manual to order replacement parts. Check for shipping
damage or missing parts. If any parts are damaged or missing, call 1-877-684-8912 for replacement.
The saw is factory set for accurate cutting. After assembling it, check for accuracy. If shipping has influenced the settings, refer to
specific procedures explained in this manual.
The table saw body with leg stand assembly B comes assembled as one unit. Additional parts which need to be fastened to the
saw should be located and accounted for before assembling:
A. Blade Guard Assembly
B. Anti-kickback Pawl Assembly
C. Miter Gauge Assembly
D. Rip Fence Assembly
E. Dust Extraction Port
F. Push Stick
G. Blade Wrench (2)
H. Outfeed Support Assembly
I. Locking Knob (2) (use for outfeed
support assembly)
Figure 1a - Unpacking (Parts for table saw)
Figure 1c – Hardware (Q-X used for leg stand)

UNPACKING

J. Stand support
K. Handle Assembly
L. Wheel (2)
M. Locking Knob (2) (use for leg stand)
N. Shock Absorption Pads (3)
O. Leveling Foot Assembly
P. Roller Sleeve (2)
Q. M6 x 35 Socket Head Bolt (2)
R. M8 x 60 Hexagon Bolt
S. M8 x 60 Socket Head Bolt (2)
Figure 1b - Unpacking (Parts for leg stand)
_ 9 _
T. M8 Flat Washer (3)
U. M8 Big Flat Washer (2)
V. M10 Big Flat Washer (2)
W. M6 Hex Nut (2)
X. M8 Hex Nut (4)
Y. 5mm Hex Wrench
Z. 6mm Hex Wrench