To Open The Leg Stand - Performax 240-3605 Operator's Manual

TO OPEN THE LEG STAND

Refer to Figures 7-9.
• Grasp the handle on the stand and stand the table
saw upright as shown Figure 7.
• Step on the release lever and pull the handle toward you at
the same time.
• Once lever releases, continue to grasp handle and push
stand down towards floor until saw is in horizontal position
(Figure 9).
• With your hands on the handle, push the stand towards the
ground until the table saw is in an open position. (Figure. 9)
NOTE: The release lever will close over the center brace,
locking the stand in an open position. (Figure. 9)
Figure 8
ASSEMBLY
Figure 7
Figure 9
_ 15 _