Page 1
ELECTRIC INSTANTANEOUS WATER HEATER EPS - 3,5 EPS - 4,4 EPS - 5,5R...
Page 2
Please, read and follow the installation and operating instructions carefully, to ensure the long life and reliable operation of this appliance. The manufacturer may make minor changes in the appliance if necessary. They will not be exposed in the operating instruction, so long as the main features of the heater remain the same. This product must not be treated as a communal waste.
Installation Fig.1 View Fig.2 Electric connection [1] – work indicator F – dipolar circuit breaker [2] – power changing knob (EPS-5,5R) L – live wire [4] – gaskets N – neutral wire [5] – filter PE – earth wire [6] – water supply BN - brown [7] – rosette BU - blue [8] – tap body GNYE - green-yellow [9] – spray-head...
Venting 1. Shut off electric supplies. 2. Turn the flow on (turn the hot water tap on) in order to vent the installation until the flow of water becomes constant and even. 3. Shut off the flow. 4. Switch on the electric supplies. ATTENTION! Vent the appliance every time after a decay of water.
Maintenance To ensure a long and faultless work of the appliance you should carry out a seasonal cleaning of the filter [5] in your individual capacity (this duty does not belong to a guarantee service). To clean the heater do the following (Fig.5). 1. Cut off water and electric supply.
Faults In case the appliance does not heat water, check for possible reasons: a failure of the mains supplies (e.g. fuses), insufficient flow through the heater (e.g. dirty filter, incorrect setting of the flow regulating valve). The guarantee does not cover the above repairs. If there is a fault in the appliance (the heater does not work and all the above reasons do not occur), contact the nearest authorised service.
Need help?
Do you have a question about the EPS - 3,5 and is the answer not in the manual?
Questions and answers