Epson GT-7000 Service Manual page 50

EPSON GT-7000
6. Remove 4 screws(CP, 2.5x6) located around the I/F connector
behind the scanner body and one screw(CP, 3x5).
7. Remove each cable from the carriage connector(lock type; pull and
release), carriage FFC connector and power unit connector(lock
type; push and release).
8. Lift up the front part of the main board, pulling it toward you, and
remove the connector from the scanner body. Then, remove the
main board.
C P ( M 2 . 5 x 6 )
Figure 4-25. Main Board Removal (2)
Rev. A
C R M o t o r
C o n n e c t o r
C P ( M 3 x 5 )
Chapter 4 Disassembly and Assembly
P S U n i t
C a r r i a g e F F C
C o n n e c t o r
C o n n e c t o r
Figure 4-26. Remove the Main Board (3)
Figure 4-27. Main Board
43