Healthrider H100T HETL79615.0 User Manual page 15

16. Remove the 5/16" Nut (94) and the 5/16" x 2 1/4"
Bolt (95) from the bracket on the Latch Crossbar
(96).
Align the upper end of the Storage Latch (63)
with the bracket on the Latch Crossbar (96), and
insert the 5/16" x 2 1/4" Bolt (95) through the
bracket and the Storage Latch. This will push
a spacer (C) out of the other end; discard the
spacer.
Next, tighten the 5/16" Nut (94) onto the 5/16"
x 2 1/4" Bolt (95); do not overtighten the Nut;
the Storage Latch (63) must be able to pivot.
Then, lower the Frame (56) (see HOW TO
LOWER THE TREADMILL FOR USE on page
23).
17. Attach the Tablet Holder (25) to the back of the
console assembly with four #8 x 3/4" Screws (2);
start all four Screws, and then tighten them.
Do not overtighten the Screws.
18. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex key in a secure
place; the hex key is used to adjust the walking belt (see pages 15 and 26). Note: Extra hardware may be
included.
16
94
C
56
17
2
15
96
95
63
25
2
Console
Assembly