Healthrider H100T HETL79615.0 User Manual page 11

8. If there are four screws (B) preattached inside
the Handrails (84, 85), remove and discard the
screws.
IMPORTANT: To avoid damaging the Pulse
Crossbar (31), do not use power tools and do
not overtighten the #10 x 1 1/4" Screws (9).
Orient the Pulse Crossbar (31) as shown.
Attach the Pulse Crossbar to the Right and Left
Handrails (84, 85) with four #10 x 1 1/4" Screws
(9) and four #10 Star Washers (5); start all four
Screws, and then tighten them.
9. With the help of a second person, hold the con-
sole assembly near the Right Handrail (84) and
the Left Handrail (not shown).
Connect the ground wire from the console
assembly to the Console Ground Wire (58) on
the Pulse Crossbar (31).
See the inset drawing. Next, connect the
Upright Wire (81) to the console wire. The
connectors should slide together easily
and snap into place. If they do not, turn one
connector and try again. IF YOU DO NOT
CONNECT THE CONNECTORS PROPERLY,
THE CONSOLE MAY BECOME DAMAGED
WHEN YOU TURN ON THE POWER. Then,
remove the wire tie from the Upright Wire.
8
9
5
85
B
9
Console
Assembly
Console
Wire
81
84
Wire
Tie
11
31
9
5
B
84
Ground
Wire
58
31
Console
Wire
81