Korg Prophecy Basic Manual page 21

WHEEL 2
The effect will increase as the wheel is moved from the lowest position away from yourself. Normally this
wheel is used to adjust the depth of vibrato.
0
CChg#01
WHEEL 3 +direction
WHEEL 3 -direction
Here's how WHEEL 2 functions when the Edit
mode Common section page CMN-5 Control
Wheel 2 parameter is set to CChg#01 . The
example is for when the Edit mode OSC section
page OSC1-4 lnt.CC#1 Ctr1 parameter is set to+.
The effects will be applied as you move the wheel away from or toward yourself, relative to the center
0 position.
If separate functions are assigned to WHEEL 3+ and WHEEL 3-, different effects can be applied by
moving the wheel in the + or- direction.
WHEEL 3 HOLD key
If this key is pressed while WHEEL 3 is being operated, the effect at that moment will be held, and will
continue even after WHEEL 3 returns to its original position. While Hold is on, the LED will light. Press
the key once again to defeat the hold function. When WHEEL 3 is at the 0 position, press the key once
again to re-apply the effect that was previously held. Also, if WHEEL 3 returns to the held location
while hold is still on, hold will automatically be canceled.
While Hold is on, you can move the wheel in the other direction to apply both effects simultaneously.
RIBBON (X)
The effect will be applied when you move your finger to left or right on the ribbon.
• Depending on the setting of Edit mode Common section page CMN-7
X
Variable Center, this can be used in
two ways.
OFF:
The left edge of the ribbon controller will be 0. If PBend+- is selected, the center will be 0.
ON:
The location where you first touch the ribbon controller will be 0.
RIBBON (Z)
The effect will be applied when you press down on the ribbon controller.
RIBBON (X): The effect will be applied when you move
your finger to left or right on the ribbon controller.
If X Variable 0 Point is OFF: the left edge of the ribbon
controller will be 0 (for PBend+-, the center will be 0).
If X Variable 0 Point is ON: the location where you first
touch the ribbon controller will be 0.
t
WHEEL 3 (+)direction: The effect
will be applied when you rotate the
wheel upward.
0
l
WHEEL 3 (-) direction: The effect
will be applied when you rotate the
wheel downward.
-·-
1
WHEEL3
1)
RIBBON (Z): The effect will be applied
when you apply pressure.
If you move WHEEL 3 to location ·a· and press the WHEEL 3
HOLD key, the effect at 'a' will be maintained even if you return
the wheel to the center.
Pedal volume (optional)
In this condition if you move the wheel to 'b', the effect specified
for WHEEL 3- will be applied as well.
Pressing a pedal volume (EXP-2, XVP-10, etc.) connected to the FOOT PEDAL jack will apply the specified
effect.
• The polarity of the pedal volume can be switched in Edit mode Global section, page GLB-4 Foot Pedal Polarity.
13