Table of Contents
Advertisement
Device Connections
Notes of connection
• To avoid short circuit of the electrical
system, disconnect the negative battery
cable before installation.
• To prevent short circuit in the wiring and
damage to this unit, secure all cables with
insulated terminals or adhesive tape.
Keep the wiring away from heat and
moving parts .
• Replace a blown fuse with one of 15A rating.
Never by-pass the fuse assembly. If the proper
fuse is installed and electrical problems still
occur, please contact a professional installer.
• Please make sure all the wiring connections to
the speakers are well insulated. This will
prevent damage from short circuit.
• If no ACC available, please connect a switch
between the ACC lead and the power supply.
• To prevent damage to the built-in power
amplifier, never ground the speaker outputs.
• The minimum rating for the speakers
connected to this unit is 45W with 4 to 8Ω
impedance.
Installation Guide
Preparation
1. Disconnect battery
Before you begin, disconnect the
battery negative terminal.
Note:
If the unit is to be installed in a car equipped
with an on-board drive or navigation computer,
do not disconnect the battery cable. If the
cable is disconnected, the computer memory
may be lost. Under these conditions, use extra
caution during installation to avoid causing a
short circuit.
2. Remove unit from sleeve
Lift latches on both sides of sleeve to remove
mounting cradle from the unit.
Mounting Sleeve Installation
1. Slide the mounting sleeve off the chassis.
If it is locked into position, use the removal
tools (supplied) to disengage it.
2. Check the dashboard opening size by
sliding the mounting sleeve into it.
If the opening is too small, carefully cut or
file as necessary until the sleeve easily
slides into the opening. Do not force the
sleeve into the opening or cause it to bend
or bow. Check for sufficient space behind
the dashboard for the unit chassis.
This unit can be installed in any dashboard
with a suitable 183 mm (W) x 52 mm (H)
opening as shown above. The dashboard
should be 4.75 mm - 5.56 mm thick in order
to be able to support the unit.
3. Locate the series of bend tabs along the
top, bottom, and sides of the mounting
sleeve. With the sleeve fully inserted into
the dashboard opening, bend as many of
the tabs outward as necessary to firmly
secure the sleeve to the dashboard.
EN - 10
Hide quick links:
Advertisement
Table of Contents
