Maintenance And Troubleshooting - NordicTrack SL 800 User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and properly tighten all parts of the exercise
cycle regularly. To clean the exercise cycle, use a
soft, damp cloth. To prevent damage to the console,
keep liquids away from the console and keep the con-
sole out of direct sunlight.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, the Right Side Shield (27) must be removed.
Using an adjustable spanner, turn the Right Pedal
(21) counterclockwise and remove it. Next, remove
the M4 x 25mm Screws (65). Turn the Right Crank
Arm (23) so that it is pointing toward the front of the
exercise cycle and then slide off the Right Side
Shield.
27
Next, locate the Reed Switch (46). Turn the Right
Crank Arm (23) until the Magnet (30) is aligned with
the Reed Switch. Loosen, but do not remove, the indi-
cated M4 x 16mm Screw (57). Slide the Reed Switch
slightly closer to or away from the Magnet. Then,
retighten the Screw.
65
23
21
65
Front View
46
23
57
30
Turn the Right Crank Arm (23) for a moment. Repeat
until the console displays correct feedback. When the
Reed Switch (46) is correctly adjusted, reattach the
Right Side Shield (27) and the Right Pedal (21).
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip whilst you are pedaling,
even when the resistance is adjusted to the highest
level, the Drive Belt (47) may need to be adjusted. To
adjust the Drive Belt, you must first remove both side
shields. See HOW TO ADJUST THE REED SWITCH
at the left and remove the side shields.
Next, turn the indicated M8 Nylon Locknut (63) until
the Drive Belt (47) is properly tightened. Then, reat-
tach the side shields.
PULSE SENSOR TROUBLESHOOTING
If the chest pulse sensor does not function properly,
see CHEST PULSE SENSOR TROUBLESHOOTING
on pages 9 and 10.
If the handgrip pulse sensor does not function proper-
ly, see step 5 on page 14.
23
47
63