Storage; Maintenance; Trouble Shooting Guide - Stamina 0890 Air Bike Owner's Manual

STORAGE

1. To store the 0890 Air Bike simply keep it in a clean dry place.
2. The 0890 Air Bike is 47" long x 25" wide x 46" tall.
3. The 0890 Air Bike must be lifted for movement. Two people may be required.
4. To avoid damage to the electronics, remove the batteries before storing the 0890 Air Bike for one year
or more.

MAINTENANCE

The safety and integrity designed into the 0890 Air Bike can only be maintained when the 0890 Air Bike is
regularly examined for damage and wear. Special attention should be given to the following:
1. Verify that the Locking Pins(40) are properly installed and the spring loaded ball near the end of pin will
keep each Locking Pin in place.
2. Adjust the Tension Knob(30) and verify that the Tension Belt(28) provides tension. The Tension Belt(28)
should provide many years of use.
3. Verify that the Thin Nuts(41) are properly tightened to prevent the pedals from coming loose.
4. Verify that the Warning Label(81) is in place and easy to read. Call Stamina Products immediately
(1-800-375-7520) for a replacement Warning Label if the Warning Label is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components shall be replaced immediately or the 0890 Air Bike removed from service
until repair is made.
7. Only Stamina Products supplied components shall be used to maintain/repair the 0890 Air Bike.
8. Keep your 0890 Air Bike clean by wiping with an absorbent cloth after use.
IT IS NOT NECESSARY TO RETURN ENTIRE BIKE FOR A MONITOR REPAIR.
THE MONITOR IS REMOVABLE FROM BIKE FOR REPAIR OR REPLACEMENT.
PROBLEM
1. No Display On Monitor.
2. No Speed Or Distance Displays
On Monitor.
3. Chain Makes Popping Noise.
4. Bike makes sudden loud noise.
5. Bike Rocks As You Pedal.
6. Resistance too high.

TROUBLE SHOOTING GUIDE

CAUSE
1. Batteries Weak Or Dead.
1. Pickup Wire Not Connected To
Monitor.
2. Speed Pickup Not Working
Properly.
3. Monitor Not Working Properly.
1. Chain Is Too Loose.
1. Chain is too loose and hits fan.
1. Bike Is Not Level.
1. Fan needs adjustment.
10
CORRECTION
1. Replace Batteries. (Use Two
AA.)
NOTE: Odometer Will Be Reset
After Replacing Batteries. See
Page 13.
1. Securely Plug Pickup Wire Into
Back Of Monitor.
2. Replace Speed Pickup.
3. Replace Monitor.
1. Adjust Chain - See Page 11
Chain Adjustment.
1. Adjust Chain
1. Adjust Leveling Caps On Rear
Stabilizer Until Bike Is Level.
1. Adjust fan per instructions on
page 11 and 12.