Hyundai HY6222 User Manual page 16

6.3.5. Press primer bulb (8) at least three times or until fuel fills the bowl.
When restarting the machine immediately after stopping leave the choke knob at the open
6.3.6. Hold the front handle (3) to secure unit firmly on the ground, pull the starter
handle (13) firmly and vigorously. DO NOT let go of the handle instead release
the handle gently allowing the cord to retract into the housing.
6.3.7. When the engine has started, push the choke knob in and pull the starter
again to restart the engine.
6.3.8. Allow the engine to warm up with the throttle lever in a midway position.
Keep clear of the saw chain as it will start to rotate when engine first starts.
6.4. Checking the chain oil supply.
6.4.1. After starting the engine, run the chain at medium speed and see if chain oil
(1) is scattered off as shown below.
position. This includes restarting a warm engine.
Page 16 Rev 2