Checking The Printer Status - Windows - Epson xp-235 SERIES User Manual

User's Guide
Light Situation
A printer error has occurred.
A Wi-Fi connection error has occurred.
The printer has started in recovery mode
because the firmware update failed.
* In some print cycles a very small amount of surplus ink may be collected in the ink pad. To prevent ink leakage
from the pad, the printer is designed to stop printing when the pad has reached its limit. Whether and how often
this is required will vary according to the number of pages you print, the type of material that you print and the
number of cleaning cycles that the printer performs. The need for replacement of the pad does not mean that your
printer has ceased to operate in accordance with its specifications. The printer will advise you when the pad
requires replacing and this can only be performed by an authorised Epson Service provider. The Epson warranty
does not cover the cost of this replacement.
Related Information
"Removing Jammed Paper" on page 84
&
"Contacting Epson Support" on page 106
&
"Installing Applications" on page 81
&
"Updating Applications and Firmware" on page 81
&

Checking the Printer Status - Windows

1. Access the printer driver window.
Solving Problems
Solutions
Open the scanner unit and remove any paper or
protective material inside the printer. Turn the power
off and on again.
If the error continues to occur after turning the power
off and on again, contact Epson support.
Press the
See the Network Guide for more details.
Follow the steps below to try to update the firmware
again.
1. Connect the computer and the printer with a USB
cable. (During recovery mode, you cannot update the
firmware over a network connection.)
2. Visit your local Epson website for further
instructions.
The printer notifies you of the firmware update status
as shown below.
Preparing: The network status lights flash.
Updating: The power light flashes.
Finished: The power light stops flashing and stays on.
83
button to clear the error and try again.