Cisco ASR 920 Series Installing Manual page 7

Hide thumbs Also See for ASR 920 Series:

Chapter 3

Installing the Cisco ASR 920 Series Router

Figure 3-4

Installing the Chassis in a 19-inch EIA Rack

Install the four M6x12mm zinc-plated steel screws through the holes in the bracket and into the threaded

Step 3

holes in the equipment rack posts.

Use a tape measure and level to verify that the chassis is installed straight and level.

Step 4

Attaching the Cable Guides

The Cisco ASR 920 Series Router supports the following cable guides:

•

If the chassis is mounted using 19-inch brackets, you must assemble the cable guides before installing

Note

the chassis on the rack.

OL-32751-01

A920-CBL-GUIDE (left and right)—help in routing the cables from all components on the front

panel thereby enabling a proper cable-bending radius.

Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide

Installing the Router in a Rack

3-7

Table of Contents