Panasonic DP-3530 Operating Instructions Manual page 13

■ Key Operator Password
● The Initial Machine Modes can be checked or changed with the Function Modes, however, these modes require
the Key Operator Password.
For Key Operator : When setting up this machine, please consult with the authorized service provider,
and decide on the Key Operator Password together, then record it and keep it in a
safe place for future reference.
■ Dept. (Departmental) Code
When the Department Counter function is set up, the Dept. (Department) Code input screen is displayed on the
LCD Display. A registered Department Code (1 to 8-digit) is required to gain access to each secured function, or
the secured Copy/Fax/Scanner function(s) cannot be used. Please consult with the Key Operator regarding the
Department Code(s) for the desired function.
Procedures :
Input a registered department code (1 to 8-digit).
Press the SET or START Key.
■ Number of Copies
The maximum number of copies is up to 999 (3 digit with keypad). During the copy mode, if you input 4-8 digit
numbers, they will be interpreted as being a phone number and displayed on the LCD, then the machine will
switch to the Fax mode.
■ Memory Full
If memory overflows during original scanning, the message "MEMORY FULL CONTINUE? 1:YES 2:NO" will be
displayed on the LCD. If this occurs, follow the instructions on the LCD. If this occurs frequently, adding optional
memory is recommended, consult with an authorized service provider.
■ Maximum Copies Limitation
After setting the maximum allowed number of copies for each department (see page 79), consult with your Key
Operator when the total copy count reaches the designated limit and the "DEPT.MAXIMUM COPIES HAS BEEN
REACHED" message appears on the LCD.
■ Power Switch
If you are not going to use the copier for long periods of time, turn OFF the Power
Switch on the Left Side of the machine and wait 10 seconds then, turn OFF the
Main Power Switch on the Back Side of the machine.
■ Auto Reset Time
As the initial setting for Auto Reset Time is 1 minute, selected default operation mode backs to default operation
mode after 1 minute. If you wish to change Auto Reset Time, consult your Key operator. (See page 70)
■ Hard Disk Deletion
There is a possibility that the machine may retain image data on the Hard Disk Drive. The Hard Disk Deletion
function overwrites the entire image data area with fixed data at Medium and with random data at High security
level setting respectively. However, the FAX/IFAX Address Book* data will not be overwritten.
(* Refer to the Operating Instructions for Facsimile and Internet Fax/Email Functions)
While this function is executing, other functions will not be accepted. The overwriting may require more time when
this function is set to a higher security level (Medium or High).
Once the execution of this function starts, the process can only be cancelled by turning the Sub Power Switch to
the OFF position.
13