Page 1
SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY. THIS MANUAL IS PRINTED ON RECYCLED PAPER. PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE PELLET STOVE Windsor OWNER’S MANUAL ���� PLEASE READ THIS ENTIRE MANUAL BEFORE INSTALLATION AND USE OF THIS PELLET-BURNING ROOM HEATER. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH.
Table of Contents Introduction......................3 Rating Label Location..................3 Important Safty Data..................3 Warnings and Recommendations..............3 Automatic Safety Features of Stove..............4 Pellet Quality....................4 Dimensions....................5 Operating Instructions....................6 Control Board Functions..................6 Turning Your Pellet Stove On................7 Turning Your Pellet Stove Off................7 Slider/Damper....................7 Routine Cleaning and Maintenance................8 Warranty.........................10 Installation Data Sheet.....................11...
Introduction ATING ABEL OCATION The rating label is located on the back of the hopper. MPORTANT AFTY This unit is designed to burn pelletized wood fuel only. Do not use any other type of fuel; this will void any warranties stated in this manual. Since Sherwood Industries Ltd.
ELLET UALITY PELLET QUALITY IS IMPORTANT, PLEASE READ YOUR ENVIRO PELLET STOVE HAS BEEN DESIGNED TO BURN WOOD PELLETS ONLY. DO NOT USE ANY OTHER TYPE OF FUEL, AS THIS WILL VOID ANY WARRANTIES STATED IN THIS MANUAL. CAUTION: It is important to select and use only pellets that are dry and free of dirt or any impurities such as high salt content.
Introduction IMENSIONS UNIT DIMENSIONS HEIGHT: 27 1/8” (68.89 cm) WIDTH: 25 5/8” (65.08 cm) DEPTH: 26 1/8” (66.35 cm) HEARTH PAD: The floor protector must be non- combustible, extending beneath the stove the full width and depth of the unit including 6 “ inches (15.2cm) front ember...
Operating Instructions URNING ELLET TOVE WITHOUT THERMOSTAT: Ensure the hopper has sufficient fuel or pellets to start the unit. 1. Press the ON / OFF button (6) to start the appliance. System light (5) will flash, auger light (3) will flash with the pulse of the auger, heat level indicator will show with no control until the system light becomes solid.
ASH PAN AND DOOR GASKETS (weekly) After excessive use, the gasket may come loose. To repair this, glue the gasket on using high-temperature fiberglass gasket glue available from your local ENVIRO dealer. This is important to maintain an airtight assembly.
Page 9
Routine Cleaning And Maintenance HEAT EXCHANGER TUBES (weekly) A rod is located under the unit top, in the center of the stove just behind the door. This handle is to be pushed in and out a few times (ONLY WHEN THE UNIT IS COLD) in order to clean away any fly ash that may have collected on the heat exchanger tubes.
Consult an ENVIRO dealer. It is recommended than only an authorized ENVIRO dealer installs an ENVIRO unit. There will be no warranty coverage on parts destroyed or burnt out as a result of a consumer installation error or defect.
Installation Data Sheet The following information must be recorded by the installer for warranty purposes and future reference. NAME OF OWNER: NAME OF DEALER: _________________________________________ _________________________________________ ADDRESS: ADDRESS: _________________________________________ _________________________________________ _________________________________________ _________________________________________ _________________________________________ _________________________________________ PHONE:___________________________________ PHONE:___________________________________ MODEL:___________________________________ NAME OF INSTALLER: SERIAL NUMBER:___________________________ _________________________________________ DATE OF PURCHASE: _____________...
Need help?
Do you have a question about the Windsor and is the answer not in the manual?
Questions and answers