Manually Select A Track To Record - Samick DCP-8 Manual

As mentioned at the beginning of this section, you can record to two independent
tracks within each song you record. This means that you can make a recording, and
after you're done, play back what you recorded while recording a complementary part
on a second track. This piano automates some of the track selections to make work
with the Song Recorder more intuitive:
When you start recording, if data has already been recorded on track 1, the display
will Show , and the Song Recorder will record on track 2.
During recording, any notes already recorded on the other track will be played back.
If you are recording on track 2, anything previously recorded on track 1 will be played
back for you to play along to.
If tracks 1 and 2 both contain data, this piano will automatically choose to record
to the track that was NOT last recorded to. (If your last recording was on track 1,
track 2 will be selected; if your last recording was on track 2, track 1 will be selected.)

Manually Select a Track to Record:

Press the [Song] button and the [Metronome] button simultaneously to enter Record
Wait Mode.
Song
Turn the Data Control knob to select between Track 1 and Track 2.
If either of the tracks contains recorded data, the display will show a dot
the bottom right hand corner:
Data Control
[Assignable]
You will also see options for
(abbreviated cAn ), which you can ignore for the moment. These will be
discussed later in this section.
Metronome
RECORD
Clear (abbreviated
28
clr ) and Cancel
in
.