Hotpoint K964GP Use And Care Manual page 35

Lower Oven
PROBLEM
OVEN WILL
NOT OPERATE
OVEN LIGHT
DOES NOT WORK
ELECTRONIC
TOUCH PADS
WILL NOT WORK
ELECTRONIC
DISPLAY PANEL
OR BLINKS
FOOD DOES NOT
BROIL PROPERLY
FOOD DOES NOT
ROAST PROPERLY
FOOD DOES NOT
BAKE PROPERLY
POSSIBLE CAUSE AND REMEDY
Difficulty may be in the main distribution panel of your house by a blown oven
circuit fuse, a tripped oven circuit breaker, the main fuse or the main circuit breaker,
depending on nature of the power supply. If a circuit breaker is involved, reset it. If
the control box uses fuses,
ONLY BY SOMEONE FAMILIAR WITH ELECTRICAL CIRCUITS. If after doing
one of these procedures, the fuse blows or circuit breaker trips again, call for service.
NOTE: Apartment tenants or condominium owners should request their building
management to perform this check before calling for service.
Door still locked. Let oven cool below 500°F.
Light bulb is loose or bulb is burned out.
OVEN LIGHT pad is defective.
Oven is in Self-Clean mode.
Clock not set. Touch CLOCK pad and enter time.
If it cannot be reset by touching pads, electrical service
caused interference signals on the main power line. Disconnect your cooking center at
the main fuse or circuit breaker panel. Wait one minute and reconnect power. Reset
clock.
BROIL and START pads not touched.
Food is being cooked on a hot pan,
Utensils are not suited for broiling.
Aluminum foil used on the broil rack has not been fitted properly and slit.
BAKE and START pads not touched.
Oven temperature not set correctly. Incorrect number pads touched.
Shelf position is incorrect. Check Roasting Guide.
Roasting pan is too small.
Improper cookware is being used.
A
foil tent was not used when needed to slow down browning.
BAKE and START pads not touched.
Oven shelf is not level.
The wrong cookware is being used.
Temperature setting is incorrect.
the oven fuse (a cartridge-type) should be changed BUT
to your residence has
35