Input Search - Panasonic TH-75SQ1W Operating Instructions Manual

Input search

When a signal is not detected, another input with a
signal is automatically selected.
Note
●
MEMORY VIEWER / Screen Transfer input is
excluded from this function.
Input search
Input search
1st search input
2nd search input
■
[Input search]
[Off]: When there is no signal, the input is
not switched automatically.
[All Searches all inputs and switches to an
inputs]: input with a signal.
Input search is executed in the
following order.
Example: When the current input is
[HDMI2] → [DisplayPort] → [DIGITAL
LINK] → [DVI-D] (or [SLOT]) → [PC]
→ [USB] → [HDMI1] →
Note
● The inputs set to [(Skip)] in [Input label] (see page 69)
are skipped when searching.
[Custom]: Repeatedly searches [Current input],
[1st search input] and [2nd search
input] in order, and switches to an input
with a signal.
[Input Monitors the inputs set to [On], detect
detection]:
the status change from no signal to
signal present, and switches to the
input.
PC
Searching...
[Searching...] is displayed during the input search.
■
[Input search]: [Custom]
[1st search input], [2nd search input]
Set the input to search when [Custom] is selected.
[HDMI1] / [HDMI2] / [DisplayPort] / [DIGITAL LINK]
/ [DVI-D] / [SLOT] / [PC] / [USB] / [(None)]
64
English
Custom
(None)
(None)
HDMI1
■
[Input search]: [Input detection]
Input search
Input search Input detection
HDMI1
HDMI2
DisplayPort
DIGITAL LINK
DVI-D
PC
Changing delay
Sets the input to monitor during [Input detection].
[HDMI1] / [HDMI2] / [DisplayPort] / [DIGITAL LINK]
/ [DVI-D] / [PC]
[Off]: The input is not monitored.
[On]: The input is monitored.
■
[Changing delay]
Sets the delay time until the input is switched during
[Input detection].
[Off]: Switches the input if a signal is interrupted
even for a very short period.
1 ‒ 10: Sets the delay time (sec.).
Switches the input when the set time has
elapsed after detecting no signal is present.
However, if the detection period during
which no signal is present is shorter than the
set delay time, the input is not switched.
Note
●
[Input detection] is the function that automatically
switches the input as below by monitoring the
presence of signal for the set input.
If a video signal is input to the set input that is
•
not displayed (When the status has changed
from signal absent to signal present.), the input is
selected and switched.
If no signal is detected for the displayed input, the
•
setting switches to the set input to which a signal is
input. Also, if no signal is present for the displayed
input when the power is turned on or when the
input is switched, the setting switches to the set
input to which a signal is input. When signals are
input to multiple set inputs, the priority order as
default (immediately after power-on) is as follows:
HDMI1, HDMI2, DisplayPort, DIGITAL LINK,
DVI-D, PC.
In the other case (When the input is switched after
power-on), the input displayed last takes priority.
●
[Changing delay] is the function to prevent the
accidental input switch during a short period, such as
when the signal is interrupted due to the frequency
change for the input signal while [Input detection] is
operating.
If a signal is detected again within the set period
(sec.), the input is not switched.
● [Input detection] may not operate correctly depending
on the image playback device.
Off
Off
Off
Off
Off
Off
Off