Cisco UCS C240 M4 Installation And Service Manual page 94

Installing or Replacing Server Components
Carefully push down on both ends of the PCIe riser to fully engage its circuit board connector with
g.
the socket on the motherboard.
Replace the top cover.
Step 6
Replace the server in the rack, replace cables, and then power on the server by pressing the Power button.
Step 7
If you replaced a RAID controller card, continue with
Step 8
RAID Controller, page
Figure 3-28
3
2
1
Securing plate hinge-tabs
2
Securing plate thumbscrew (knob not visible
on underside of plate)
Cisco UCS C240 M4 Server Installation and Service Guide
3-52
C-23.
PCIe Riser Securing Features (Three-Slot Riser Shown)
Chapter 3
Restoring RAID Configuration After Replacing a
1
3
GPU card power connector
4
Card-tab retainer in open position
Maintaining the Server
4
OL-32474-01